The controller installed into the customer system must be positioned so that
NOTE
cold air can flow through the PCB components. Do not install or use the
controller in an environment exposed to atmospheric agents (rain, snow, ice),
dust, aggressive gases, or in explosive environments or those with a high fire
risk.
During operation, the following environmental conditions must be
respected:
Use
This paragraph describes the fundamental operating procedures.
Detailed information and operating procedures that involve optional
connections or options are supplied in the paragraph "USE" of the
appendix "Technical Informations". Some procedures can be executed
with controller only when the accessory "Hand held terminal" is
available. Make all vacuum manifold and electrical connections and
refer to Turbo-V pump instruction manual prior to operating the
Turbo-V controller.
WARNING!
To avoid injury to personnel and damage to the equipment, if the pump is
laying on a table make sure it is steady. Never operate the Turbo-V pump if
the pump inlet is not connected to the system or blanked off.
Turbo-V 1000HT PCB Controller User Manual / 87-900-906-01
temperature: from 0 °C to +40 °C
relative humidity: 0 – 95 % (without conden-sation).
Instructions for Use
(F)
16
Use
199/262