Initial Start-Up; Important Notes; Rotary Speeds; Changing The Speeds - Heiniger EVO Traducción Del Manual Original

3

Initial start-up

3.1

Important notes

WARNING!
y The voltage specified on the maker's plate and that of the local
power supply must match. The plant may only be connected to
an AC power supply.
y It is a compulsory that the operator has read the safety regu-
lations.
y In the event that the plant is operated from a generator, the
mains supply voltage must not exceed that specified on the
maker's rating plate.
3.2

Rotary speeds

The three-speed portable shearing plant is specially designed for profes-
sional use.
The lowest speed is ideal for inexperienced shearers and for shearing un-
der difficult conditions.
The medium speed setting is suitable for shearers with average shearing
skills and for running in new shearing handpieces.
The high speed setting is for experienced, professional shearers who de-
mand high shearing performance.
3.3

Changing the speeds

CAUTION!
An authorised service point in compliance with the following in-
structions may only carry out changing the speed!
Pull out the plug from the socket.
X
Remove the cover by loosening the nine screws (Diag. 2, pos. a). A plate
X
bearing the speed specification is fitted beneath the cover. See also
Chapter 4.2, "Service".The self-tensioning belt tensions the belt automa-
tically.
Push the belt by means of a slight movement so that the drive axis turns
X
into the new desired position (Diag. 2, pos. c). To ensure that the belt
is not damaged, do not use any auxiliary aids when changing speeds.
Make sure that the belt is located in the grooves at the same height on
both axis.
Re-secure the cover using the nine screws (Diag. 2, pos. a).
X
8
EVO Shearing Plant – Translation of the original instructions