3. Plug the connection cable into the machine.
4. Plug the connection cable into the mains
socket.
Fig. 18
1. Switching on: Switch to "1" (Green button).
2. Switching off: Switch to "0" (Red button).
Drum positions
Fig. 19
1. Operating position (can swivel to the right or
left).
Information:
When released, the hand wheel must
lock into position in the retention plate.
Fig. 20
Transportation and storage
Warning!
The drum must be rotating when it is
being filled or emptied. Do not overfill
the drum!
1. If there are any prolonged breaks in work,
disconnect the power and safeguard the
concrete mixer to prevent it from being
switched on by unauthorised persons.
Transportation
Danger!
!
Before moving the concrete mixer,
always pull out the machine plug.
1. Swivel down the filler opening.
2. If transporting the concrete mixer in a vehi-
cle, fold in the feet after removing the upper
bolts and slackening the lower bolts (Fig. 3).
3. Tie down the concrete mixer to prevent it
from moving.
Maintenance
Danger!
!
Before carrying out any work on the
concrete mixer, switch off the concrete
mixer, wait until the drum has come to a
standstill and disconnect the power. The
concrete mixer may be repaired by
authorised specialist companies only.
GB 4
Maintenance intervals
Before use
1. Visually check the concrete mixer.
2. The concrete mixer must not be operated if
3. Visually check the connection cable. To do
Cleaning the drum
1. Wash out the drum with gravel and water.
2. Remove encrusted cement and mortar. Do
Maintenance work
Tensioning the drive belt
Fig. 21
1. Take the motor off the frame.
2. Remove the 3 caps (21-3) from the motor
3. By applying pressure to the motor shaft
4. Re-tighten the fastening bolts and insert the
5. Mount the motor.
Troubleshooting
If any faults occur, switch off the concrete mixer,
pull out the mains plug and have the fault(s)
rectified by an authorised specialist company.
Protection of the environment,
disposal
Übersetzung der Original-Gebrauchsanleitung: Instructions for use
any parts of the machine are missing, defec-
tive or loose.
this, fully unwind the connection cable. A de-
fective connection cable (e.g. insulation
cracked, cut, crushed or kinked) must not be
used.
Warning!
Do not lubricate (grease) the ring gear.
not strike the drum or mixer housing with
hard objects (e.g. hammer, shovel, etc.).
housing and slacken the fastening bolts
(Fig. 21-2).
(21-1), push the drive motor as far down as
possible and hold it there.
caps.
The device must not be included
in household waste.
The appliance, its packaging and
accessories are all produced from
recyclable materials and must be
disposed of accordingly
Concrete mixer
.