Instructions For Use; Turning It On/ Off; Operating Modes; Recharge - SPC BAAMBA GYRO PRO SUCTION 4400 Manual De Instrucciones

EN

3. INSTRUCTIONS FOR USE

3.1 TURNING IT ON/ OFF

Turn the robot fully on and off using the side switch.
The robot will enter resting mode if it has not done anything for 10 minutes.
The robot cannot be turned off if it is charging.

3.2 OPERATING MODES

Make a short press on the button for the robot to start automatic cleaning when turned on.
Click on Auto in the SPC IoT application for automatic cleaning.
Click on Back to charging base in the SPC IoT application to send the robot to the charging base.
Press the button on the remote control to start automatic cleaning.

3.3 RECHARGE

When it has finished cleaning, the robot will return to its charging base.
If the battery becomes too low when cleaning, the robot will return to its charging base.
The robot will turn itself off automatically if the battery is completely drained: you can then place it
on the charging base by hand, but please make sure that the electrodes are correctly aligned, or you
can connect the power cable to the robot's side socket, and the button will flash green.

3.4 MANUAL MODE

You can control the robot manually from the application or the arrows on the remote control.

3.5 WALL FOLLOW

Select this cleaning mode in the application or remote control for more thorough cleaning of the
edges of the room.

3.6 MOP

Select this mode from the control panel of the application or from the remote controllere button
once the water tank is placed to use the mop.

3.7 SPIRAL

You can select this mode from the application so that the robot cleans one area more intensely and
spirals outwards from there.

3.8 PAUSE

Press button on the robot or on the remote controller. You can press either button again
to continue the cleaning.

3.9 RESTING

The robot will automatically enter resting mode if it has not performed any action for 10 minutes.
You can reactivate the robot by pressing the button or using the SPC IoT application.
The robot will not enter resting mode if it is on the charging base.

3.10 ERROR

If an error occurs, the button will flash red and the robot will emit 3 beeps, go to the
"Troubleshooting" section at the end of the manual to find the solution.