Ideal 61-955 Manual De Instrucciones página 18

Breaker
Energized
Breaker
Energized
Tracing Conduit.
1) Clamp around the metallic conduit to be traced. If possible, ground the far end of the
conduit to close the loop. This can be created using the 25' lead and alligator clips to clip
onto the end of the conduit or electrical box with one clip and a remote neutral or water
pipe with the other alligator clip.
2) Hang the battery pack onto the panel or conduit with the magnetic strap.
3) Plug the clamp into the battery pack.
4) Set the receiver to the highest sensitivity (
Receiver is saturated, reduce the sensitivity range.
Weaker Signal - Open
Stronger Signal - Closed
) mode and trace the conduit. If the
Page 18
Light On
(Load)