Dometic GROUP Waeco PerfectCharge CA360 Instrucciones De Montaje página 29

All manuals and user guides at all-guides.com
Perfect Charge CA360
2.2 Safety when installing the device
DANGER! Danger of electrocution
D
 For installation on boats:
If electrical devices are incorrectly installed on boats, corrosion
damage might occur. Have the inverter installed by a specialist
(marine) electrician.
 Do not touch exposed cables with your bare hands. This espe-
cially applies to all cables in the AC mains circuit.
 If you are working on electrical systems, ensure that there is
somebody close at hand who can help you in emergencies.
 Never mount the device anywhere where there is a risk of gas
or dust explosion.
CAUTION!
!
 Ensure that the device is standing firmly.
The device must be set up and fastened in such a way that it
cannot tip over or fall down.
 Make sure that the lead has a sufficient cross-section.
 Lay the cables so that they cannot be tripped over or damaged.
 Fasten the cables securely.
 Do not expose the device to a heat source (such as direct sun-
light or heating). Avoid additional heating of the device in this
way.
NOTICE!
A
 If cables have to be fed through metal walls or other walls with
sharp edges, use ducts or bushings to prevent damage.
 Do not lay cables which are loose or bent next to electrically
conductive material (metal).
 Do not pull on the cables.
 Do not lay the 230 V mains cable and the 12 V DC cable in the
same duct.
 Set up the device in a dry location where it is protected against
splashing water.
 Protect the device against corrosive fumes and salty or moist
air.
 Protect the device and the cable against rain and moisture.
EN
General safety instructions
29