Bosch SensorSteam TDS12 Serie Instrucciones De Uso página 12

en
• "eco" setting is automatically selected.
• The "ActiveControl Advanced" indicator lamp (3)
• The "ActiveControl Advanced" indicator lamp (3)
• The pump starts working and steam is generated
automatically.
• Steam generation will stop.
• The "ActiveControl Advanced" indicator lamp (3) will
• The iron shuts off automatically. If the handle is
gripped again, the iron turns on.
• After the handle (1) is touched or the steam activation
button (2) is pushed again, the green light starts
• Steam generation will not be possible for several
seconds, until the appropriate working temperature
has been reached.
Steam can be generated in two ways :
• Set the steam control to "eco" or "max" position.
• Grip the handle (1).
• Set the steam control to the "
continuous steam generation while gripping the handle
(1). On this setting, steam can only be produced
when manually pressing the steam activation button
(2) under the handle.
• Press the steam activation button (2).
• Steam is only available if the temperature control (15)
is set at the steam symbols
"max".
• Adjust the temperature setting and then set the
steam control according to the table below. Steam
will automatically be produced:
Temperature control (15) setting
••
••• to "max"
12
Note: Once a steam ironing setting has been chosen
using the temperature control (15), steam generation
may be delayed for several seconds until the appropriate
working temperature has been reached.
• Grip the handle (1) and set the steam control to the
• The temperature control (15) adjusts the temperature
• While ironing, do not press the steam activation
• Do not use the spray function with silk as staining
• When ironing, press the spray button (7) and water will
• Set the temperature control (15) to the "•••" or "max"
• Set the steam control to the "max" position.
• Press the shot of steam button (6) on the handle
" position, to cancel
• Set the temperature control (15) to the "•••" or "max"
- between "••" and
• Hold the iron in an upright position about 15 cm away
• Press the steam activation button (2). The shot of
Steam setting
max
setting.
of the soleplate (13). Set it to the corresponding
position by lining it up with the temperature index (14)
on the iron.
Select an appropriate temperature for the type of
material being ironed (see "setting the temperature"
section).
button (2).
may occur.
spray out of the spray nozzle (10) onto the garment.
position.
repeatedly at intervals of 5 seconds.
position and the steam control to the
from the garment being steamed.
steam button (6) on the handle may be additionally
pressed at intervals of 5 seconds. However, after
4 shots of steam, wait for 10 seconds to allow for
continued steam production.
position.