Setting Up The Surround Amplifier - Sony S-master WAHT-SBP1 Manual De Instrucciones

Setting up the surround
amplifier
Front panel
POWER / ON LINE
Indicator
POWER/ON LINE
PHONES jack
Rear panel
EZW-RT
S-AIR ID
SURROUND SELECTOR
SURROUND
SELECTOR switch
1
Set the SURROUND SELECTOR
switch of the surround amplifier
of this kit to SURROUND BACK.
2
Set the S-AIR ID switch of the
surround amplifier to match the
ID (A, B, or C) of the S-AIR main
unit.
3
Press POWER on the surround
amplifier.
The POWER / ON LINE indicator
turns green. If not, see "Checking the
transmission status" (page 9).
POWER
POWER
PHONES
S-AIR ID switch
10
SPEAKER
A
B
C
L
PAIRING
R
SURROUND
SURROUND
BACK
4
Set up the speakers.
If the S-AIR main unit has the Auto
Calibration function, perform Auto
Calibration.
If the S-AIR main unit does not have
the Auto Calibration function, perform
the appropriate speaker setting.
For details, refer to the operating
instructions of the S-AIR main unit.
Checking the
transmission status
You can check the status of sound
transmission between the S-AIR main unit
and surround amplifier by checking the
POWER / ON LINE indicator on the
surround amplifier.
POWER / ON Status
LINE indicator
Turns green Sound transmission is
established.
Flashes green Sound transmission is not
established.
Turns red The surround amplifier
does not output sound.
Turns off The surround amplifier
turns off or its protection is
active.
For details, see "Troubleshooting"
(page 12).
9
GB