COLLEXIA PROFESSIONAL NST D9201 Manual De Instrucciones página 13

Electrical safety - danger of electric shock
WARNING: Keep the device away from water. Do not
use this device in the vicinity of bath tubs, wash basins or
other containers that hold water!
• If you use the device in the bathroom, the power plug must
always be disconnected after use because the proximity to
water can be dangerous even while the device is switched off.
• For additional protection, the installation of a residual current
device (RCD) having a rated residual operating current not
exceeding 30 mA is advisable in the electrical circuit supplying
the bathroom. Ask your installer for advice.
• Before connecting the appliance, check that the mains voltage
information on the type plate matches the specifications of your
power network. The type plate is located inside the housing of
the appliance.
• When using an electrical appliance, always follow these basic
rules:
- Never touch the appliance with wet or damp hands or feet.
- Never use the appliance in bare feet.
- When disconnecting the power plug, always pull on the plug
itself and not on the cord or the appliance.
- Never subject the appliance to humidity or weather
influences (rain, sunlight).
• Always disconnect the power plug from the power supply
before cleaning or servicing the appliance and while it is not in
use.
• Do not use the appliance if the housing or the power cord are
damaged or if the appliance does not work properly. If the
power cord of this appliance is damaged, it must be replaced
All manuals and user guides at all-guides.com
Danger of fire and explosion
• Only place the device on heat-resistant surfaces and do not
• Keep the device away from highly flammable liquids and
• Never operate the appliance without supervision.
Injury hazard
• The titanium-anodised plates and the surrounding parts of the
• Be careful to avoid direct contact between the hot surfaces of
• Only bring the plates into contact with your hair for a short time,
Danger of material damages
• Never use the device with synthetic hair or wigs.
• Keep the plates clean and free from dust, dirt, gel, hair setting
• Do not wind the power cable around the device.
by an authorised customer service centre in order to prevent
associated dangers.
cover it (e.g. with hand towels) during operation.
objects.
device become very hot during operation. Direct skin contact
presents a risk of burns!
the device and skin, in particular the ears, eyes, face and neck.
otherwise the hair could be damaged.
Attention: To avoid overheating of the hair, do not stop the
motion while the hair is pressed between the plates.
lotion, styling spray, etc. These substances could permanently
damage the plates and their coating.
7