Vertical Cutting / Edge Trimming; Cleaning And Maintenance; Cleaning - Grizzly Tools ERT 450-20 Traducción Del Manual De Instrucciones Original

GB
Long grass should be cut at layers from
top to bottom.
Vertical cutting / edge
trimming
• Be particularly careful and attentive
when holding the cutter head verti-
cally. To avoid injuries, keep enough
distance to the cutting thread.
• To prevent the thread from wearing
out quickly, avoid contacting solid sur-
faces.
• To trim lawn edges, slowly move the
appliance along the lawn edges.
• Vertical trimming is best done by mov-
ing the appliance on its castor roll.
• You can also tip the chassis to the left
or right and use it as a guide for edge
trimming.
Vertical cut settings:
• Handle rod: 180° (see
• Cutting angle: Vertical (see
• Spacer bow in parking position
• No chassis
Cleaning and
maintenance
Always disconnect the plug
from the mains socket before
working on the trimmer.
Any work that is not described
in these Instructions must be
carried out by a servicing agen-
cy authorized by us. Only use
original parts and be very care-
ful with the line cutter during in-
stallation work. Danger of injury!
64

Cleaning

Always keep the trimmer clean. Do no
use cleaning agents and solvents.
•
•
•
‚
)
ƒ
)
1. Disconnect the plug from the mains
2. Turn over the trimmer so that the cut-
3. Simultaneously press the two locks on
4. Insert the new spool with the smooth
Do not jet water onto the trim-
mer and do not clean it under
flowing water. This would result
in the danger of an electric
shock and the trimmer could be
damaged.
After the work has been completed
remove all grass and soil from the cut-
ting device and the protective cover.
Ensure that the ventilation slots are
always clean and free of grass.
Clean the trimmer with a soft brush or
a cloth.
Never manipulate the cutting de-
vice by inserting worn out origi-
nal or alien parts. Only use origi-
nal spare parts. Never use metal
lines. The use of alien parts can
result in serious personal injury
and cause irreparable damage
to the trimmer and the guaran-
tee will become instantly null
and void.
Exchanging the line spool:
socket.
ting head (13) is facing upwards.
the cutting head (13) and remove the
hood (21) with the line spool (22).
side facing upwards in the cutting
head and thread the two lines through
the line eyelets (23). Ensure that the
line ends do not slip out of the spool
slots.