Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TROUBLESHOOTING
Remove all items from inside the warming drawer, and allow the
unit to cool completely before attempting
to remove the drawer.
To Remove:
f.
Open drawer to its full open position.
2.
Locate the black triangle-shaped
tabs on both sides of the
drawer.
1. Tab
3.
Press the tab down on the right side, and lift tab up on the left
side at the same time, then pull drawer out another inch.
4.
Holding the drawer by its sides, not its front, carefully pull it
all the way out.
To Replace:
1. Align the drawer glides with the receiving guides.
2.
Push drawer in all the way.
3. Gently open and close the drawer to ensure it is seated
properly on the slides.
Try the solutions suggested here first in order to avoid the cost of
an unnecessary service call.
Nothing will operate
•
Is the power outlet properly wired and polarized? Try
another outlet to check for proper wiring and polarity.
IS the power supply cord unplugged? Plug into a properly
grounded outlet.
Has a household fuse been blown or has the circuit
breaker been tripped? Replace the fuse or reset the circuit.
Is the main or regulator gas shutoff valve in the off
position? See Installation Instructions.
Is the range properly connected to the gas supply?
Contact a Sears trained repair specialist or see Installation
Instructions.
Surface
burners will not operate
•
Is this the first time the surface burners have been used?
)_
Turn on any one of the surface burner knobs to release air
from the gas lines.
•
On some models, is the Cooktop Lockout set? See
"Cooktop
Lockout" section.
•
Is the control knob set correctly? Push in knob before
turning to a setting.
•
Are the burner ports clogged? See "Sealed Surface
Burners" section.
Surface
burner flames are uneven,
yellow
and/or noisy
•
Are the burner ports clogged? See "Sealed Surface
Burners" section.
Are the burner caps positioned properly? See "Sealed
Surface Burners" section.
Is the burner damaged? On models with caps, look for a
warped cap. If cap will spin freely on a flat surface, painted
side down, the cap is warped. Switch cap with a different
surface burner to check for further warping. Contact a Sears
trained repair specialist. See back cover.
Is propane gas being used? The appliance may have been
converted improperly. Contact a Sears trained repair
specialist. See back cover.
Surface
burner makes popping noises
•
Is the burner wet? Let it dry.
Excessive heat around cookwara
on cooktop
•
Is the cookware the proper size? Use cookware about the
same size as the surface cooking area, element or surface
burner. Cookware should not extend more than 1 in. (2.5 cm)
outside the cooking area.
21
Tabla de contenido
