Setting The Control Unit - BelFox Drive Portal Instrucciones De Montaje

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Risk of crushing at the closing edges
While the gate is moving, limbs and fingers may be pinched or crushed
between the gate and the main closing edge and the secondary closing edges!
SAFETY WARNINGS FOR HAZARD AVOIDANCE
• Do not touch the main or secondary closing edges while the door is
moving.
Ensure that children do not touch the main or secondary closing edges
while the door is moving.
Danger of crushing on the gear rack
During gate travel, limbs and fingers may be pinched or crushed between the
gear and the rack!
SAFETY WARNINGS FOR HAZARD AVOIDANCE
• Do not touch the gear or rack while the gate is moving.
• Ensure that children do not touch the gear wheel or gear rack during the
gate movement.

21.2. Setting the control unit

The electrical connection must be made according to the enclosed control
instructions "47-21-0" (optionally "47-21-i").
• The 8-pin dip switch of the control unit 47-21-0 is used to activate special
functions of the motor control unit. It is not a coding switch for the radio.
• The gate requires a mechanical end stop in the end positions "OPEN"
and "CLOSED" so that the gate cannot run out of the guide in case of a
fault.
WARNING
WARNING
NOTE
31
Tabla de contenido
loading

Este manual también es adecuado para:

Drive portal 800i

Tabla de contenido