Sportline Solo 910 Manual Del Usuario página 4

6. Clean the front sensors and back metal plate with a mild soap and
water or similar cleaning solution. Stop if OK or
7. Moisten with water the pads of the fingers that you are using to
contact the sensors on the face of the watch. Stop if OK or
8. Moisten with water the surface between the back metal plate of the
watch and the skin on your wrist.
Sportline Solo 910 Heart Rate Watch Features and Button
Operation Overview
Metal Back Sensor
Light Button
Mode Button
Back View of Watch
1. Press the MODE button to select the desired feature mode.
The Heart Rate Watch feature modes (displays) are:
• Time
- Set time, date, 12H/24H display mode, and Button Beep ON/OFF
• Alarm
- Set alarm time, turn alarm ON/OFF, turn hourly chime ON/OFF
• Chronograph
- Run chronograph
• CountdownTimer
- Set/run timer countdown
6
SP3637IS03SPO.indd 7-8
All manuals and user guides at all-guides.com
ST/STP
(start/stop)
Button
:
6 00
AL
2 18 :
P
Sensor
Reset
Button
Front View of Watch
2. Once you have selected a feature mode, to change a setting in
that mode, hold the MODE button down for 2-3 seconds until the
display flashes.
• When in 'Button Beep ON' mode (watch default), the Sportline Solo
910 Heart Rate Watch will beep when the buttons are pushed.
3. Once flashing, to set a feature use the ST/STP button to increase and
RESET button to decrease the setting.
4. To move to the next setting, press and release the MODE button.
5. To save new settings after completion, hold the MODE button down
for 2-3 seconds until the display stops flashing.
Setting Time and Date
1. While in the Time mode hold the MODE button down for
2-3 seconds until the display flashes.
2. The 'seconds' display will flash. In order, the settings to enter
will be:
-seconds
-minutes
-hours
-year
-month
-day
Month-day then appear flashing
-12Hr (am/pm) or 24Hr (military) time mode
-Button Beep ON or OFF (buttons beep when pressed when ON, no
beeping when OFF)
7
9/19/11 11:55 AM