Norcold 2118 Manual Del Usuario página 2

9. Return to . (Fig. 4) Make sure:
A A1
• A2 is attached to A ; position
• Lower edge of K1 overhangs into
A1
A
A2
Fig. 4
Install Fin Shingle
1. If necessary, thoroughly clean and dry area
2. Remove one (1) - two (2) inches of adhesive backing from lower rear of
3. Without allowing the adhesive to touch and adhere to the rear wall of
refrigerator, carefully push upper edge (non-adhesive back side) of
under C about 1/8 inch (Fig. 5). DO NOT touch adhesive.
K2
Fig. 5
If you UNABLE push
NOTICE
If you ARE ABLE to push
Step 5.
4. LOOSEN (8x) with one (1) - two (2) turns only. DO NOT remove
C1
(Fig. 6).
C
Fig. 6
5. Without allowing the adhesive to touch and adhere to the rear wall
of the refrigerator, carefully push the upper edge (non-adhesive
back side) of K2 up under
touch adhesive.
A in small drip cup.
.
A
K1
again (Fig. 2).
D2
C
up under , go to Step 4.
K2 C
up under , go directly to
K2 C
C about 1/8 inch (Fig. 5). DO NOT
6. With in the correct position, remove the adhesive backing.
K2
7. Firmly press the entire adhesive area of
• For best results, apply pressure to the adhesive using a seam roller or
other hard smooth surface that will not leave a mark (such as a large
spoon or an ice cream scoop).
• Allow adhesive to cure for 72 hours.
8. Tighten (8x) that were loosened in Step 4. DO NOT over tighten.
C1
Examine for External Condensation
1. Examine the fl oor in front of the refrigerator for any water and the fl apper of
the fresh food doors for any condensation.
• If you see any water, examine contact pins of the left-hand door for tape.
• If any tape is present, remove the tape.
.
K2
up
K2
C
2
onto . Refer to Fig. 2.
K2 D2
www.norcold.com