Norcold 2118 Manual Del Usuario

Kit Contents: K1, K2
New Description
K1 Drip Tray Shingle (adhesive on upper / rear)
K2 Fin Shingle (adhesive on lower / rear)
Tools Needed:
■ Seam roller (or a large spoon / ice cream scoop)
■ Torx 25 screwdriver or bit - minimum four (4) inches long
This procedure is to be performed by authorized service
WARNING
!
personnel only. Improper installation, adjustment,
ATTENTION
alteration, service or maintenance can cause injury or
property damage.
Purpose:
Use this kit to improve the effi ciency of redirecting condensation from
the fi ns to the drip tray.
Install Drip Tray Shingle
New Description New
A Drip Tray B
A1 Drip Tray Rails C / C1
A2 Drip Tray Drain Tube D
Reference: Fig. 1 - Fig. 3
For successful installation, parts must be thoroughly dry
NOTICE
before applying adhesive backing.
1. Remove all food from refrigerator.
2. Allow refrigerator to warm up to room temperature.
3. Remove (shaded); place on
A
D
A1
A
Fig. 1
Printed in U.S.A./Imprimé aux É.-U./Impreso en EE. UU.
P.O. Box 1285
Ann Arbor, MI 48106
www.norcold.com
2118 Drip Tray Condensation Kit
K1
Description
Refrigerator Shelf
Fins, Fin Screws
Interior Refrigerator Wall "V"
(Fig. 1).
B
4. Using warm soapy water, clean
wall; thoroughly dry. (Fig. 2)
D2
D1
Fig. 2
5.
C may continue to drip water - be sure everything is thoroughly
dry before continuing.
6. Remove adhesive backing from rear of
adhesive.
7. Attach K1 to the refrigerator cabinet liner as indicated by arrows
(Fig. 3).
NOTICE
• Make sure "V" point of
("V" point shown in black).
• Press the adhesive surface of
• will lay behind the front surface of the
K1
liner.
D4
Fig. 3
B
8. Start at the top corners and fi rmly press the entire adhesive area of
.
D4
• For best results, apply pressure to the adhesive using a seam roller or
other hard smooth surface that will not leave a mark (such as a large
spoon or an ice cream scoop).
• Allow adhesive to cure for 72 hours.
Service Kit
Ensemble de réparation
Juego de servicio
K2
and shaded areas of refrigerator
D1 D2
C
K1 . DO NOT touch the
The D3 hole shown may or may not be present in
refrigerator cabinet.
K1 (shown shaded) is directly below the
against the top edge of
K1
"V" feature in the cabinet
E
D3
K1
Part No./N° de pièce/Pieza n°. 637963C (09.04.2018)
637962
D3
.
D4
D4
K1 onto