Stanley SPS-1400 Traducción De Las Instrucciones Originales página 14

G
Never cut against hard objects such as stone, etc.
B
This way you avoid injuries, and damages to the tool.
Never use the tool without the guards attached.
Never use your hands to stop the cutting device.
Always wait until it stops on its own.
Hold and guide the trimmer head as close to the ground as possible.
Only cut grass growing on the ground. Do not cut
Dgrass in cracks in walls, growing or on rocks, etc.
Always make sure no objects, or other debris is
collecting in the trimmer head, in the protective
hood, or in the engine.
Only use the tool, when the guard is attached.
Always switch off the tool, before you put it down.
Keep in mind that there is risk of injuries in the area of
the cutting device intended to cut off the line.
CAUTION: The cutting tool continues rotating for a few
seconds after the engine is turned off.
Put the tool down only after the cutting tool has
completely stopped and the motor is turned off.
When the cutting tool is damaged, it must be
replaced at once.
Always use the original line only. Never use a metal wire
instead of the nylon line.
Tool and cutting tools must be properly inspected
and serviced periodically. Damages must be
repaired by a service center.
Only use accessories recommended by the
manufacturer.
Have your tool serviced only by qualified personnel and
by use of original spare parts only.
This ensures that the tool will work safely in the future.
14
Assembly
Check if all parts are included and if they were
damaged during transport before assembly.
1. Place the tool horizontally with the engine facing
towards the ground.
2. Release the clamp screw (19) (A1), and insert the top
and bottom Trimmer tube into the provided connector (A2).
3. Slightly twist the bottom Trimmer tube to
engage the retention pin (20) in the bore hole of
the connector. Then tighten the clamp screw.
4. To disassemble, loosen the clamp screw, push
the retention pin inwards, and pull the Trimmer
tube apart (A4).
Handlebars
The design of the petrol brush cutter allows for
operation at the right side of the user's body.
- Put the bigger spring(24) into the bottom side of the
rotatable bracket(23). (B3-2)
- Press the smaller(25) spring into the top side of the
rotatable bracket(23).(B3-3)
- Put the handle bar(2)into the slot of the rotatable
bracket(23).(B3-4)
- Connect and close the bracket cover(26) and rotatable
bracket(23) by using the hooks on the bracket cover.(B3-5)
- Insert the Clamp screw for handrail holder (1) through
the bracket cover(26) and rotatable bracket(23).(B3-6)
- Put the bracket assembling onto the bracket base
(22) and slightly tighten the Clamp screw for handrail
holder (1) .(B3-7&B3-8) - Adjust the handle bar into the
operating angle and tighten the Clamp screw for handrail
holder (1).(B3-9)
When you store the tool, you can slightly loose the Clamp
screw for handrail holder (1) and rotate the handle bar to
parallel with the main shaft for save storage space.(B4-
1&B4-2)
Assembly of Line Cassette
To avoid the risk of an unwanted engine start, pull