Idiomas disponibles
Idiomas disponibles
General
This hand-held air impact wrench consists simply of a motor connected to the drive spindle through
reduction gearing. Torque delivered by the tool is adjusted by regulating the pressure of the air
entering the motor. The operator applies the tool to the fastener, starts the motor and allows it to run
until the torque in the fastener builds up to the point where the motor stalls. This is a perfect tool for
tightening or loosing threaded fasteners in work areas such as that of a body and automotive
workshops, construction, light assembly in electrical, mining, marine... etc
Safety
Always follow the safety rules and instructions in this manual to avoid the risk of personal Injury and
property damage. It is absolutely necessary to study the operating manual before starting this tool.
Keep these instructions in a safe and accessible place.
Before using the tool ensure you have full understanding of the tool's application and limitations,
as well as the specific hazards that apply to it.
x
Do not over reach keep proper footing and balance at all times.
x
Always wear approved ear protection.
x
Never use gasoline or other flammable liquids to clean the tool. Vapor in the tool can be ignited by
sparks and cause the tool to explode.
x
The work area where the tool is used should be kept clean. An unclean work area is a potential
cause of accidents.
x
Other people should be kept away from the working area.
x
Consider the working area environment. Do not expose air tools to rain or use them in damp or
wet locations. Keep the work area well lit.
x
Do not use air tools in the presence of flammable liquids or gases.
x
When not in use air tools should be stored in a safe place.
x
Always wear approved safety goggles.
x
Do not wear loose clothing or jewelry as they can be caught in moving parts.
x
At all times stay alert, watch what you are doing and be constantly aware of your working
environment.
x
Non-skid footwear are recommended.
x
When not in use and before performing any service or changing accessories, ensure air tool is
disconnected.
x
Be sure to use only good quality accessories, damaged tools such as couplings, fittings, etc., can
flake off during operation and fly around the work area.
x
Before use make a visual check. Make sure that the square drive and the trigger is OK and there
is no crack in housing.
x
Do not use if there is any defective.
The manufacturer will not accept any responsibility for injury or damage caused by improper use of
this tool. If you have any question, please contact our authorised representatives.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
½" Air Impact Wrench
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Art. 3280
