Helvi FOX 185 FLEX-LINE Manual De Uso página 22

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

6.
Selector switch for the Welding Modes Selection: MMA, TIG, MIG manual, MIG Syn.
7.
Right Knob: it is used to adjust the following welding parameters.
a.
in STICK Mode it adjusts the over-current value of the electric arc (Hot Start), variable from 0
to 50% on the current value adjusted with the Left Knob (8).
b.
In TIG Mode is not active.
c.
In MIG manual it adjusts arc voltage value (no load) from 12V to 26V. When the machine
is supplied with 115V the maximum value is 24V.
d.
In MIG Synergic it selects the thickness of the material to be welded.
8.
Left Knob: it is used to adjust the following welding parameters.
a.
In STICK Mode it adjusts the current value from a minimum of 20Amp to a maximum of
170Amp When the machine is supplied with 230V power. When the machine is supplied at 115V the
maximum value adjustable is 100Amp.
b.
In TIG Mode, when supplied with 230V, it adjusts the current value from a minimum of 5
Amp to a maximum of 170Amp. When the machine is supplied at 115V the maximum value adju-
stable is 110Amp.
c.
In MIG manual it adjusts the wire speed.
d.
In MIG Syn it adjusts the wire speed; possible variation is +/-40% on the base value adjusted
by default ( "0" on the display).
9.
Negative Dinse socket:
a.
in STICK welding for the connection of the ground cable connector (check for correct polarity
for the electrode you are going to use, refer to the information on its box);
b.
in TIG Welding for the TIG torch cable connection;
c.
in MIG welding (with gas) for the connection of the ground cable connector.
10.
Positive Dinse socket:
a.
in STICK welding, for the connection of the ground cable connector (check for correct pola-
rity for the electrode you are going to use, refer to the information on its box);
b.
in MIG Flux Core Welding (FCAW), for the connection of the ground cable connector
11.
Euro connect for attaching the MIG torch cable. In MIG Flux Core welding (FCAW), change the
polarity of the Euro socket using the terminals on the polarity change board located inside the wire
spool compartment above the wire feeder -18-).
12.
Input power cable
13.
ON/OFF Switch
14.
Gas Hose connector
15.
2 roll Aluminum wire feeder
16.
Slope up Time regulation potentiometer
17.
Burn Back Time Regulation Potentiometer (B.B.T.)
18.
Polarity Change Terminals for the Euro Socket:
a.
positive polarity for MIG/MAG Welding;
b.
negative polarity for No Gas Welding.
19.
Spool holder for wire spools ø 100 and 200mm
Figure 3
19
22
-ENGLISH-
16
17
18
15
Tabla de contenido
loading

Tabla de contenido