Assembly - Shindaiwa LE242/EVC Manual Por Propietario/Operador

Assembly

Prior to assembly
Before assembling, make sure you have all
the components required for a complete unit.
Carefully inspect all components for damage.
■
Outer Tube/Main Shaft Assembly
■
Cutting Attachment Shield
■
Edger Blade
Mounting the cutting attachment shield and edger blade
1. Loosen gearcase clamp bolt.
2. Remove the gearcase index bolt.
3. Slide the gearcase oriented as shown
onto the shaft tube insuring that the
flex drive is engaged in the gearcase.
4. Reinstall the index bolt and tighten
securely.
NOTE:
It may be necessary to pull the flex cable
out from the shaft tube, engage into the
gearcase and then slide the assembly
onto the shaft tube.
5. Tighten the clamp bolt and torque to
52 – 69 inch-pounds.
Adjust Throttle Lever Free Play
The throttle lever free play should be
approximately 4 - 6 mm (3/16" - 1/4").
Make sure that the throttle lever operates
smoothly without binding. If it becomes
necessary to adjust the lever free play, fol-
low the procedures and illustrations that
follow.
1. Loosen the air cleaner cover knob and
remove the air cleaner cover.
2. Loosen the lock nut on the cable
adjuster.
3. Turn the cable adjuster in or out as
required to obtain proper free play
4-6 mm.
4. Tighten the locknut.
5. Reinstall the air cleaner cover.
6
All manuals and user guides at all-guides.com
■
Kit containing cutting attachment shield,
mounting bracket and hardware, this
owner's/operator's manual, and a tool
kit for routine maintenance.
Gearcase
index bolt
Gearcase
Remove air cleaner cover
Throttle Lever Free Play
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front" and
"rear" refer to directions as viewed by the
operator during normal operation.
Gearcase
clamp bolt
Cable
Adjuster
Adjust as required for 4-6 mm free play
4-6 mm (3/16"-
1/4")Throttle Free
Play
IMPORTANT!
Shaft tube
Flex drive
Lock Nut