Assembly - Shindaiwa AH242 Serie Manual Del Propietario - Operador

Assembly

Prior To Assembly
Before assembling, make sure you have
all the components required for a com-
plete unit:
■
Engine/outer tube assembly
■
Gearcase/cutter assembly
Connect the Outer Tube to the Powerhead
1. Place the powerhead on a clean, flat
surface, spark plug facing up.
2. Use the 4 mm hex wrench to loosen the
tube clamp screw.
3. Slide the outer tube into the tube
clamp until the tube bottoms. If instal-
lation is difficult, rotate the outer tube
or main shaft slightly until you feel
the mainshaft splines engage with the
powerhead.
CAUTION!
Do not force the shaft tube into the
powerhead! Excessive force can dam-
age the shaft tube and mainshaft.
4. Position the outer tube so that the
gearcase output shaft is facing left on
muffler cover.
Connect the Throttle Cable
1. Loosen the air cleaner cover knob and
remove the air cleaner cover.
2. Loop the ribbed cable tube under the
tube and to the top left side of the
engine and push cable through the
cable adjuster.
NOTE
Make sure the ribbed cable tube is on
the left side of the engine before connect-
ing the throttle cable.
3. Connect the bullet shaped end of the
throttle cable to the throttle lever on
top of the carburetor.
4. Connect ignition leads.
CAUTION!
Wiring runs must not interfere with
throttle operation.
6
■
Kit with this manual and tool kit for rou-
tine maintenance.
■
Cutter blade cover
Carefully inspect all components for
damage.
Outer Tube Trigger
Housing
Connect outer tube to powerhead
5. Slide the outer tube into the powerhead
until the throttle grip just contacts the
tube clamp.
6. Tighten the clamp screw firmly.
Filter
Cover
Loosen air cleaner cover knobs
End of
throttle cable
Connect bullet shaped end of
throttle cable
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front" and
"rear" refer to directions as viewed by the
operator during normal operation.
Clamp Screw
Mainshaft
Grip
Hex
Wrench
Tighten clamp screw firmly
Throttle Cable
Push throttle cable through the cable
adjuster
Ignition Lead
Connect end of
throttle cable here
Connect ignition leads
IMPORTANT!
Spark
Plug
Tube Clamp
Tube
Clamp
Cable
Adjuster
Ignition
Leads