Am-600; Output - Biamp AudiaFUSION Manual

100 meters. Additional Ethernet switches and/or fiber-optic cable can be used to further extend distances between units on a network.
Please note that CobraNet limits network extensions to seven hops (one-way transmissions) within a network.
The primary and secondary CobraNet ports are redundant. Each connector provides two LEDs that indicate Ethernet link and network
activity (see table below).
Left LED Right LED
None None
Green None
Green Flashing
amber
Flashing Flashing
green amber
Flashing Flashing
amber amber
Table 1 . CobraNet interface status LEDs

AM-600

AM-600 is the Amplifier Module card. An AudiaFUSION chassis can be populated with up to eight AM-600 cards.

Output

Use the yellow plug-in barrier strip connectors to connect loudspeaker level outputs. If stranded speaker wire is used, be sure to incorporate
all strands into the connector, as stray strands can short to the adjacent terminal or chassis. Do not leave excessive bare wire outside
the terminals, as this can lead to shorts.
AudiaFUSION REAR PANEL
Description
No data connectivity. .
Link established.
Link established and CobraNet activity detected; the unit is acting as a CobraNet performer.
Link established and CobraNet activity detected; the unit is operating as a CobraNet conductor.
CobraNet fault. Check cabling and configuration for errors.
Please note: AudiaFUSION is a powerful amplifier and can
damage loudspeakers. Please treat the outputs as you would
AC mains power outlets. Always check the loudspeaker's
continuous and peak power capabilities and match the amplifier
settings accordingly.
7