Audiafusion; Features - Biamp AudiaFUSION Manual

AudiaFUSION is the newest member of the Audia
and device- and load-monitoring capabilities. AudiaFUSION features an 8-channel modular amplifier, 16x16 I/O via CobraNet
with support for channel-to-channel and device-to-device failover. AudiaFUSION can support up to 8 amplifier cards that are individually
software configurable from 100-600 watts for up to 2400 watts of power, with software-selectable 70V, 100V and low impedance outputs
per card. Intuitive software provides audio system design via PC and allows easy selection, viewing and calibration of numerous audio
components: mixers, combiners, matrixes, equalizers, filters, crossovers, dynamics, routers, delays, meters, generators, diagnostic tools,
and more. Once a system design is compiled, it is downloaded into AudiaFUSION, where it can be controlled via AMX,
third-party control system, or via computer running daVinci™ control software. When installed in a system together, AudiaFLEX and Audia-
FUSION processing resources are allocated as needed, making the whole system more efficient. .

FEATURES

• Modular based design
• Amplification modules have software configurable power
levels/load options
– 8 amplification modules per frame with 100W to 600 Watts
per module (maximum of 2400W per chassis)
– 70 V or 100 V with direct drive capability, or low-impedance
(4 or 8Ω) operation
– Maximum of 2400 watts of power in 3 rack unit device
• TCP/IP Network controllable
• LED Indication:
– Signal present
– Peak present
– Clip present
– Heat sink temperature fault
– Amplifier failure
– Fan stuck-rotor
• Internal amplifier module failover mode
• Entire device failover mode

AudiaFUSION

family, bringing together open-architecture DSP, Multi-Channel Amplifier technology,
®
• Software Monitoring Features:
– Peak present
– Heatsink temperature value, warning and fault
– Short circuit on output
– Amplifier failure
– Impedance min/max threshold warning
– Excessive clipping
– Fan stuck-rotor
• Seamless integration with CobraNet-enabled Audia systems
• CobraNet Interface (16 channels in/16 channels out)
• CobraNet latency 5-1/3, 2-2/3 or 1-1/3 ms,
software configurable
• Dual Ethernet ports for redundancy
• Selectable 115/230 volt operation
• Control via RED-1, daVinci or third party control via RS-232
or TCP/IP
• CE marked, UL listed and RoHS compliant
• Covered by BIAMP Systems' five-year warranty
3
alarm
activity
signal 1 status
power
signal 2 ais
and DSP
®
Crestron, other
® ®