Audiafusion & Am-600 Card Specifications - Biamp AudiaFUSION Manual

AudiaFUSION SPECIFICATIONS
Inputs:
Connection:
Environment:
Ambient Operating
Temperature Range:
Ambient intake humidity:
Altitude:
Power:
AM-600 Card SPECIFICATIONS
Supported Loads:
Continuous operation:
(in chassis with fans running
normally and unrestricted
intake and exhaust)
Signal-to-Noise Ratio:
(unweighted over 22 Hz – 20 kHz)
100W
200W
300W
400W
500W
600W
AudiaFUSION SPECIFICATIONS
20 bits, 48 kHz, supported CobraNet latency
5-1/3, 2-2/3 or 1-1/3 ms
software configurable
RJ45 with shielded Ethernet cable
(CAT5, CAT5e, CAT6, or CAT7)
32-95 degrees F (0 – 35° C)
0 – 100% non-condensing
0 – 10,000 Feet MSL
110~120 & 220~240 VAC 50/60Hz
switch selectable
4Ω 8Ω, 70-Volt Line, or 100-Volt line direct drive
6Ω not shown in GUI
400 W: 1 kHz continuous sine wave indefinitely
600 W: 1 kHz continuous sine wave for at least
2400 Watt maximum per chassis
Low-
impedance 70V
>95 dB >100 dB
>98 dB >101 dB
>99 dB >101 dB
>101 dB >102 dB
>102 dB >102 dB
>102 dB >103 dB
Overall Dimensions:
Height:
Width:
Depth:
Weight:
Chassis:
AM-600 card:
Compliance:
1. In chassis with fans running normally and unrestricted intake and exhaust
Frequency response:
Distortion and Noise:
3 minutes
Intermodulation
distortion (SMPTE):
100V
>101 dB
Inter-channel Isolation:
>102 dB
>102 dB
>103 dB
>103 dB
DC offset:
>104 dB
10
5.25 inches (133mm)
19 inches (483mm)
17.25 inches (438mm)
50 lbs. (22.68 kg)
1.25 lbs. (0.57 kg)
EU Directive 2002/95/EC, RoHS directive
UL listed
CE marked
20 Hz – 20 kHz frequency response flat (+/-1
≤0.3% THD+N (20 Hz – 20k Hz) all loads and
power levels
>75 dB (20 Hz-20 kHz, full power out)
dB)
<0.2%
<10mV