Uline H-4408 Manual De Instrucciones página 3

Figure 8
4b. Using other end of assembled X-brace from the
right frame, attach to the bottom hole and top
hole on the middle frame. With the second
assembled X-brace, attach to the middle frame
using the same bottom hole and top hole (the
brace ends overlap). Only one notched end may
be on the bottom hole and one on the top hole.
Hand tighten. (See Figure 10)
Figure 10
4c. Attach assembled X-brace to the left frame using
the other end of assembled X-brace. Hand tighten.
NOTE: Not all holes on the frame will be used.
4.
PAGE 3 OF 24
ASSEMBLY CONTINUED
Figure 9
4d. At this point frame is able to stand up on its own.
Make sure the frame is straight, square and level.
Tighten all 3/8" bolt connections with socket
wrench. (See Figure 11)
Figure 11
5. On the frame, place a clip on each hole of the seat
and foot braces. On the foot braces for rows 1-3,
use the intermediate holes. The clips should have
the center indent facing up and be horizontal. Insert
5/16" carriage bolt through each clip and frame
and attach nut loosely. (See Figures 12-13)
Figure 12
Rows 1-3
Intermediate
Figure 13
Holes
0521 IH-4408