Uline H-4408 Manual De Instrucciones página 2

1. Attach 2 x 10" end caps to seat planks and foot
planks. (See Figure 1) Attach 1 x 6" end caps to
risers. (See Figure 2) Ensure the pre-drilled holes on
the end caps are on the underside of the planks.
Use a rubber mallet to tap into place. Attach with a
drill and #2 Phillips bit using #8 x 1/2" self-tapping
stainless screws. (See Figures 1-2)
#8 x 1/2" Self-Tapping Screws
2 x 10" Plank (upside down)
Figure 1
#8 x 1/2" Self-Tapping Screws
Riser (upside down)
Riser End Cap
Figure 2
2. Assemble cross braces (X-Bracing). Place equal
length angle piece and flat bar together aligning
center holes. Attach using 3/8" bolt and flange nut
through the center hole. Hand tighten but allow
for the parts to move freely. Repeat for all other
X-braces. (See Figures 3-4)
Figure 3
3/8" Bolt and Flange Nut
Figure 4
PAGE 2 OF 24
ASSEMBLY
2 x 10" End Cap
1 x 6" End Cap
3. Position frames in place, standing up, six feet apart.
(See Figure 5)
Figure 5
4a. Working from the back of the frames, at the fifth
seat frame, attach the assembled X-brace:
notched end to the top hole and the other end to
the right frame bottom hole. Attach with 3/8" bolts
and flange nuts. Hand tighten. (See Figures 6-9)
Figure 6
Figure 7
Flange Nut
6'
6'
Bleacher Frame
X-Brace
3/8" Bolt
0521 IH-4408