Setup Mode - Urrea UD87 Manual De Usuario

E N G L I S H
This mode is very useful when it is impossible
for you to press the HOLD button or see
the meter display while probing and taking
measurements.
MEM
Use this memory mode to store and recall
measurement values. Press the MEM button
momentarily in order to activate the
memory mode. The display shows four menu
selections: Store, Recall, Clear and EXIT.
Store
Select Store to store the held value in the
next available memory location. The memory
location number momentarily shows on the
secondary display. If no memory locations are
available , shows on the secondary display
for two seconds and nothing is stored, when
you must clear the memory locations using
the Clear key in order to store the held value.
Recall
Select Recall to review the stored value using
the menu key. The secondary display shows
the value stored in that location. Whenever
you press "+" or "–" menu key, the next or
previous stored value will be shown in the
primary display and the secondary display
momentarily shows
memory location.
Clear
Select Clear to clear all the stored values.
When you press Clear key, the meter will ask
you with the display of
with the On Screen Menu Selections of AC
(stands for ALL Clear), Clear and EXIT. When
you press the Clear key, the displayed value in
he primary display is erased. When you press
the AC key, all the stored values are erased
and the word
32
the corresponding
along
shows on the display.
Press EXIT key to exit memory mode without
erasing the stored values.
EXIT
Select EXIT to exit memory mode. You can
also exit memory mode by pressing MEM
button or turning the rotary knob position.
(Backlight) Button
Press the MEM ( ) button until the backlight
is turned on or off.
On Screen Menu Selection Keys. Appears
on the display. Press the corresponding
menu selection key to select the desired
measurement.
Each setting of the rotary switch to a
measurement function position may activate
one or more menu selection key settings on
the LCD.
If there is more than one measurement
for a rotary switch setting, a menu.

Setup Mode

The Setup Mode allows you to customize
default settings. To activate the Setup Mode,
press the menu key 4 while the display shows
all segments on at power on reset.
You can customize the following default
settings in sequence during the Setup cycle.
The newly customized default values in any
Setup can be saved only when the entire
Setup cycle is ended. The meter displays
at the end of the entire Setup cycle. The Setup
values are saved on EEPROM so they cannot
be lost when the meter is turned off.
• Enable or disable the auto-power-off mode
The meter displays
display, (or
and "+", "-", EXIT in the on screen menu
selection. You can toggle EnbL/dISA by
pressing the "+", "-" menu keys.
Press the EXIT menu key to get into the next
in the secondary
) in the primary display