Ove Ra Ll D Im En Sio N S; M At E Ri Al In Co N T Act W It H T H E Ad D It Iv E; Installation; In T R O D U Ct I O N - Etatron eOne MA Normas De Instalación, Uso Y Manutención

The values listed above are intended to be within a tolerance of +/- 5%. They were obtained by a series of test
performed on similar equipments with water at temperature of 20°C.
Overall dimensions
Material in contact with the additive
In the standard configuration the pumps of the "eOne" series are supplied with the following materials:
Pump Head
PVDF

INSTALLATION

Introduction
This section describes steps for installing the pump, hoses and wiring. Please read this instruction before starting any
activity.
Follow these guidelines when installing the pump:
Fig. 1 - Dimensions in mm. Plate for wall mounting.
Membrane
PTFE
Make sure the pump is powered off and any other related equipment before starting any activity.
•
In case of any unusual events or warning signs, stop immediately. Start again only when you are absolutely
•
sure that any possible problem has been solved.
Do not install the pump in hazardous environments such as at risk of fire or explosion.
•
Avoid risk of electrical type and or fluid leakage. Never use a damaged or defective pump.
•
Seals Valves
CERAMIC
TFE/P
TFE/P
Connections Pipes
PVDF PE / PVC
Pump
Casing
PP
ENGLISH 25