Viqua VH200 El Manual Del Propietario página 7

Installation
2. Select a suitable location for the disinfection system and its related components. As it is recommended to install a GFCI,
make sure that this is taken into consideration prior to any installation. The system can either be installed vertically (inlet
port at the bottom) as shown in
the most preferred method. When selecting a mounting location, leave enough space to allow the removal of the UV
lamp and/or quartz sleeve (typically leave a space equal to the size of the chamber itself).
3. Mount the system to the wall using the supplied clamps. Various connection methods can be used to connect the water
source to the system, however union type connectors are recommended. The use of a flow restrictor device will help to
maintain the manufacturers rated flow. The flow restrictor should be installed on the outlet port and is designed to be
installed in one direction only. Ensure that the flow of the water matches the flow direction as indicated on the flow
restrictor. Refer to
Note: DO NOT solder connections while attached to the system as this could damage the O-ring seals.
4. Mount the VIQUA ICE controller horizontally to the wall, near the chamber. Ideally place the controller above the
chamber and away from any water connection point, to prevent any water from potentially leaking onto the controller by
means of a leak at a connection point or a "sweating" system. Make sure you allow for a "drip-loop" as shown in
on the lamp, sensor, and power cord, again, to prevent any water from potentially entering the controller.
7
Figure 3 A, or horizontally as shown in
A
Figure 3 Disinfection Installation - Vertical and Horizontal
Figure 4.
Flow
Flow
restrictor
Figure 4 Flow Restrictor
Figure 3
Unit overall length
B
Optional temparature
management valve
B. However, the vertical installation is
Min. clearance equal
to unit overall length
Figure 5