Bosch 1619EVS Instrucciones De Funcionamiento Y Seguridad página 13

BM 2610933969 09-12_BM 2610933969 09-12.qxp 9/20/12 9:19 AM Page 13
TRIGGER SWITCH AND
"LOCK-ON" BUTTON
Your router can be turned ON or OFF by
squeezing or releasing the trigger. Your router is
also equipped with a "Lock-ON" button located to
the left of trigger that allows continuous operation
without holding the trigger.
TO LOCK SWITCH ON: Squeeze trigger,
depress button and release trigger (Fig. 2).
TO UNLOCK THE SWITCH: Squeeze trigger
and release it without depressing the "Lock-ON"
button.
If the "Lock-ON" button
WARNING
is
depressed, the trigger cannot be released.
Always make sure that the bit is not touching the
work when turning the switch on or off. Contact
the work with the router after the router has
reached full speed, and remove it from the work
before turning the switch off. Operating in this
manner will prolong switch and motor life and will
greatly increase the quality of your work.
SOFT START FEATURE
Electronic feedback control minimizes torque
twist customary in larger routers by limiting the
speed at which motor starts.
ELECTRONIC VARIABLE SPEED CONTROL
The electronic speed control feature allows motor
speed to be matched to cutter size and material
hardness for improved finish, extended bit life,
and higher performance. Speed changes are
achieved by rotating Speed Control Dial
FORWARD to decrease speed, BACK to
increase speed, as indicated on housing (Fig. 12).
Speed may be changed while tool is on. The
reference numbers on the dial facilitate re-setting
control to desired speed.
continuously being
FIG. 12
SPEED
CONTROL
DIAL
The speed chart indicates the relationship
between settings and application. Exact settings
are determined by operator experience and
preference. The bit manufacturer may also have
a speed recommendation.
DIAL
SETTING RPM
1 8,000
}
2 9,000
3 11,000
}
4 13,000
5 17,000
}
6 21,000
CONSTANT RESPONSE™ CIRCUITRY
The router's Constant Response™ Circuitry
monitors and adjusts power to maintain the
desired RPM for consistent performance and
control.
-13-
APPLICATION
Large diameter bits
(Raised Panel)
Hardwood,
Non-ferrous metals,
soft Plastics
Softwoods, counter tops,
Smaller dia. router bits,
Hard plastics,
Decorative Edges