Machine Setup - Amano American Sanders FloorCrafter Manual Del Operador

EN
Figure 7
ransporting the Machine
NOTE: This is accomplished by removing the motor from the chassis
and transporting the motor and chassis separately.
To transport the machine, follow this procedure:
1. Make sure the power cable is disconnected from the electrical outlet.
2. Release the tension on the drive belts using the quick release lever.
ee u e 6A )
3. Open the belt guard by pulling on the handle immediately above the
e t t uck hee ee u e 6
4. Remove the drive belts from the machine
5. Disconnect the motor pigtail from the handle pigtail if so equipped.
ee u e
6 c e the oto ou t
ee u e 8
t e the oto
lift the motor off the chassis and take it to the work site.
8 L t the ch
and bring the belt guard against your chest. Take the chassis to the
work site.
To assemble the machine after transporting, follow this procedure:
1 e the e t u oo
c e the oto ou t
secure the motor.
2 t the e e t
release lever.
3. Check the tension on the belts and close the belt guard door.
AU I N: remature earing ai ure can occur i the an e t
is set too tight
the center of the span with 5 lbs. of pressure.
NOTE: It is necessary to adjust the fan belt independently
during this procedure or during replacement. The
idler pulley is factory adjusted.
ne erson
k o to oo e the oto
the oto t h e
the o t e h e
ce the oto e o the ch
k o u c e t to e
hte the e t u the e t te o
he an e t shou d deflect
ransporting the Machine
1 e o
2 e o
ou e
L t the e
To set-up your machine, follow this procedure:
1. Familiarize yourself with the machine and read all danger,
warning, and caution statements. Make sure all operators
o th
c
e
before allowing anyone to operate the sander.
2 Loc te the e ect c
u ck
be compatible with the plug. The receptacle must be
grounded and must be fused (see nameplate for electrical
requirements) to avoid an electrical hazard.
3
at strings on the dust bag and draw tight over the flare on the
elbow. Wrap the string around the elbow and secure.
4. Wind the electrical cord through the cable arm.
ee
equipment. Do not connect the electrical cord at this time.
9
Figure 8
arr ing
1 lifts the machine by the front handle.
2 t the ch e the o e t

Machine Setup

ch e h e e th e to
ot e th u h e the
ou ce he ece t c e hou
the u t to the e o ee
u e 10 ee the o e co out o
o eop e
h e
u the
u ex e u
u e o the
th o