Starting Pull Start Engines - DeWalt DXGNR 6500 Manual De Instrucciones

Operation
Add recommended engine oil as necessary.
5.
Replace oil fill cap and hand-tighten.
6.
Some units have more than one oil fill
NOTICE:
location. It is only necessary to use one
oil fill point.
Fuel
Never fill fuel tank indoors. Never fill
fuel tank when engine is running or
hot. Do not spill gasoline on a hot engine. Allow engine to
cool before filling fuel tank.
Do not overfill fuel tank. Always leave
room for fuel expansion. If fuel tank is
overfilled, fuel can overflow onto a hot engine causing
FIRE or EXPLOSION. Wipe up any spilled fuel immedi-
ately.
Gasoline is highly FLAMMABLE and
its vapors are EXPLOSIVE. Never
permit smoking, open flames, sparks or heat in the vicin-
ity while handling gasoline.
Fuel requirements are as follows:
•
Clean, fresh, unleaded gasoline.
•
Minimum rating of 87 octane/87 AKI (91 RON).
•
Up to 10% ethanol (gasohol) is acceptable (where avail-
able; non-ethanol premium fuel is recommended).
•
DO NOT use E85.
•
DO NOT use a gas oil mix.
•
DO NOT modify engine to run on alternate fuels. Stabilize
fuel prior to storage.
Verify unit is OFF and cooled for a minimum of two minutes
1.
prior to fueling.
Place unit on level ground in a well ventilated area.
2.
Clean area around fuel cap and remove cap slowly.
3.
Slowly add recommended fuel (A). Do not fill above lip (B).
4.
Install fuel cap.
5.
14
A
000116
NOTICE:
IMPORTANT: It is important to prevent gum deposits
from forming in fuel system parts such as the carburetor,
fuel hose or tank during storage. Alcohol-blended fuels
(called gasohol, ethanol or methanol) can attract mois-
ture, which leads to separation and formation of acids
during storage. Acidic gas can damage the fuel system of
an engine while in storage. To avoid engine problems,
the fuel system should be emptied before storage of 30
days or longer. See the
engine or carburetor cleaner products in the fuel tank as
permanent damage may occur.

Starting Pull Start Engines

CAUTION
ing or stopping unit. Failure to do so could result in
equipment and property damage.
Unplug all electrical loads from the unit's receptacles before
1.
starting engine.
Place generator on a level surface.
2.
Open the fuel shut-off valve (A).
3.
Turn engine Run/Stop switch (B) to Run (manual start only).
4.
Allow spilled fuel to evaporate before
starting unit.
Storage section. Never use
Equipment and property damage. Dis-
connect electrical loads prior to start-
A
Owner's Manual for Portable Generator
B
000400
000208