DeWalt DW830 Manual De Instrucciones página 7

DW830,etc./569590-01 8/3/00
depress the switch locking button next to the trigger (B). Hold the
locking button in as you gently release the trigger. Release the locking
button and the tool will continue to run. To turn the tool off from a locked
on condition, squeeze and release the trigger once.
Fitting a Rubber Backing Pad (Fig. 6)
The rubber backing pad is available as an optional accessory. To fit the
pad:
1. Unplug the tool.
2. Remove the guard from the tool.
3. Insert the backing pad onto the machine spindle (Fig. 6). The inner
driven flange in Fig. 9 is not needed.
4. Position the abrasive disc on the pad.
5. Screw the outer flange with the two grip holes, together with the pad
fitted, onto the machine spindle (Fig. 7).
6. With your finger firmly on the spindle lock (Fig. 8), tighten the outer
flange with the pin spanner supplied.
7. Release the spindle lock. You can now plug the tool in and start
work.
8. To remove the backing pad, follow the instructions in reverse order.
IMPORTANT: When using the tool for sanding, allow only a segment
of the disc to contact the work and refrain from high-pressure
application.
Mounting Grinding Wheels
The grinding wheels are available as optional accessories. To fit a
grinding wheel:
1. Disconnect the plug.
2. Locate the inner driven flange on the drive flats on the machine
spindle (Fig. 9).
3. Place the wheel against the flange.
4. Screw the threaded flange onto the spindle (Fig. 10).
5. Rotate the grinding wheel while pressing the spindle lock (on the
front of the gear case) fully until it has found its locking location and
hold the spindle still.
2:47 PM Page 4
FIG. 8
FIG. 10
FIG. 11
4
FIG. 9
FIG. 13
FIG. 12
10° - 15°