Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Problem
• Unit will not start.
For assistance with your product, visit our website at www.blackanddecker.com for a list
of service centers, or call the Black & Decker Customer Care Center at 1-800-544-6986.
GENERAL INFORMATION
HELPFUL HINTS
• Hold your angle grinder with one hand on
the body and the other hand firmly around
the side handle as shown in Figure 9.
• Always position the guard so that as
much of the exposed disc as possible is
pointing away from you.
• Be prepared for a stream of sparks when
the disc touches the metal.
• Maintain an angle between the disc and
work surface (Fig. 10) of approximately
30° when grinding and 10°-15° when
sanding ( Fig. 11) for best tool control,
material removal, and minimal loading.
CAUTION:
Use extra care when
grinding into a corner as a sudden, sharp
movement of the grinder may be
experienced when the wheel contacts a
secondary surface.
WARNING:
Always wear eye protection
while operating this power tool.
MAINTENANCE
CLEANING
Blowing dust and grit out of the motor
housing using compressed air is a
necessary maintenance procedure.
CAUTION:
Dust and grit from metal
grinding often accumulate on interior
surfaces and could create an electrical
shock hazard if not cleaned out.
Use only mild soap and a damp cloth to
clean the tool. Never let any liquid get
inside the tool; never immerse any part of
the tool into a liquid.
TROUBLESHOOTING
Possible Cause
• Cord not plugged in.
• Circuit fuse is blown.
• Circuit breaker is tripped.
• Cord or switch is damaged.
Possible Solution
• Plug tool into a working outlet.
• Replace circuit fuse. (If the
product repeatedly causes the
circuit fuse to blow, discontinue
use immediately and have it
serviced at a Black & Decker
service center or authorized
servicer.)
• Reset circuit breaker. (If the
product repeatedly causes the
circuit breaker to trip,
discontinue use immediately
and have it serviced at a Black &
Decker service center or
authorized servicer.)
• Have cord or switch replaced
at a Black & Decker Service
Center or Authorized Servicer
LUBRICATION
Black & Decker tools are properly
lubricated at the factory and are ready
for use. Tools should be lubricated
regularly every year depending on usage.
(Tools used on heavy duty jobs and tools
exposed to heat may require more frequent
lubrication.) This lubrication should be
attempted only by trained power tool
repairperson's such as those at Black &
Decker service centers or in other qualified
service personnel.
REPLACEMENT PARTS
Use only identical replacement parts.
For a parts list or to order parts, visit
our service website at www.Black &
Deckerservicenet.com. You can also
order parts from your nearest Black &
Decker Factory Service Center or Black
& Decker Authorized Warranty Service
Center. Or, you can call our Customer
Care Center at 1-800-544-6986.
SERVICE AND REPAIRS
All quality tools will eventually require servicing
and/or replacement of parts. For information
about Black & Decker, its factory service
centers or authorized warranty service centers,
visit our website at www.blackanddecker.com
or call our Customer Care Center at 1-800-544-
6986. All repairs made by our service centers
are fully guaranteed against defective material
and workmanship. We cannot guarantee repairs
made or attempted by others.
You can also write to us for information at
BLACK & DECKER, 701 E. Joppa Rd., Towson,
MD 21286. - Attention: Product Service. Be sure
11
Tabla de contenido
