SICK SLT Instrucciones De Operación página 14

8
OPERATION
8.2.1.2.1 STATUS page
14
Device information
4
Page navigation
5
Notifications
6
Update page
7
Restore factory settings
8
Activate/Deactivate Edit mode
9
Parameterization page, with sub-pages if applicable
ß
Operating mode
à
Table 2: Function
Menu
Start
Device information
Page navigation
Notifications
Update page
Restore factory settings
Edit
Operating mode
The "STATUS" page is the start page for the SLT. On this page, you can set the process
data that is cyclically transmitted to the SLT. The process data available for writing
differs depending on the operating mode set.
Click this button to show/hide the "Page selection" menu to make
it easier to navigate on smaller screens. The button is highlighted
in light blue when the device tree is hidden.
Click the Start button at any time to return to the "STATUS" device
page.
The product name, the application-specific name, the firmware
version, and the serial number are displayed in this area at the top
left.
Clicking on the individual levels displays different parameterization
pages.
Notifications for the SLT are displayed at the bottom of the screen.
They are provided for informational purposes when exchanging
parameterizations or when errors occur. Each notification can be
acknowledged by clicking on the entry.
After clicking on this button, the page contents are updated.
When you click on this button, all settings of the SLT are reset to
their factory values.
Click the Edit button to change the settings on the current parame‐
terization page. When the Edit button is pressed, it is highlighted in
light blue. Configurable pages are displayed in gray until Edit mode
is activated.
With the SLT, there is only the RUN operating mode. No password
is provided for this operating mode. With other SICK products,
there are other operating modes that require entry of a password.
8026183 / 2021-04-29 | SICK
Subject to change without notice