Powering The Transmitter; Using The Rechargeable Battery - HumanTechnik earis Instrucciones De Servicio

Powering the transmitter

Select the appropriate country adapter and insert it into the power supply
unit until it clicks into place.
Connect the power supply unit to the transmitter with the yellow "5V DC
1.5A" power socket. Then plug the power supply unit into an electrical
mains outlet.

Using the rechargeable battery

Insert the supplied battery into the receiver with the slant facing upwards
until it clicks into place.
Charge the receiver completely and without interruption before first use.
A complete charge of 100% takes about 4 hours.
When the battery is low, the status LED on the receiver flashes and you
hear a beep every 30 seconds. Then, after a few minutes, the receiver will
automatically switch off.
To charge the battery, place the receiver in the charging dock of the tran-
smitter. The LED bar must point upwards. Magnets keep the receiver in the
correct charging position.
The charging status LED on the front of the receiver starts flashing red. The
charging status LED switches to green when the battery is fully charged.
English 35