After Washing - Haier HW80 Manual Del Usuario

EN
6.10 Start wash programme
Touch "Start/Pause" button (Fig. 6-8) to start. The LED of the"Start/
Pause" button stops flashing and lights up continuously.
Appliance operates according to present settings.
Changes are only possible by cancelling the programme.
6.11 Interrupt / cancel wash programme
To interrupt a running programme press gently "Start/Pause". The LED above the button
is flashing. Press it again to resume operation.
To cancel a running programme and all its individual settings:
1. Touch"Start/Pause" button to interrupt the running programme.
2. Touch Power
3. T o u h c h t e P " o
are off) and run programme Spin to drain the water.
4. After closing the programm to restart the appliance, select a new programme and
start it.

6.12 After washing

Note: Door lock
For safety reasons the door is locked partially during the washing cycle. It is only pos-
sible to open the door at the end of the programme or after the programme was can-
celled correctly (see description above).
In case of high water level, high water temperature and during spinning it is not pos-
sible to open the door; Loc
1. At programme cycle end END is displayed.
2.
3. Remove laundry as soon as possible to go easy on it and to prevent more wrinkling.
4.
5. Unplug the power cord.
6. Open the door to prevent formation of moisture and odours. Let it open while not used.
Note: Standby-mode / energy -saving mode
The switched on appliance will go into standby-mode if it will not be activated within 2
minutes before srarting the programme or at the end of programme.The display swits-
ches off. This saves energy, To interrupt the standby mode touch "Power" button
6.13 Activate or deactivate the buzzer
The acoustic signal can be selected if necessary:
1. Switch on the appliance.
2. Select the
M X I
3. Touch the "Delay "button and "Temp." button at the same time for about 3 sec-
onds. "bEEP ON " will be displayed and the buzzer will be activated.
For deactivating the buzzer touch these two buttons at the same time again. "bEEP OFF"
will be displayed.
w r e b " t u o t n o t u t n r
is displayed.
l -
programme.
o n h t e p a p a i l c n , e select "no Speed" (speed lights
6-Daily use
6-8
17