Installation; Rf Safety; Antenna Precautions; Radio Frequency Radiation Exposure Information - Grundfos CIM 2 Serie Instrucciones De Instalación Y Funcionamiento

3. Installation

Warning
Before beginning installation, make sure
that the power supply has been switched
off and that it cannot be accidentally
switched on.

3.1 RF safety

Installers and end users must be provided
with these installation and operating
Note
instructions and operating conditions for
satisfying RF exposure compliance.
The antenna used for the product in which the
CIM XXX is fitted must be installed to provide a
separation distance of at least 20 cm from persons
and must not be co-located or operated in
conjunction with any other antenna or transmitter.
• Do not operate the product near medical devices.
This also applies to personal devices, such as
hearing aids and pacemakers.
• Do not operate the product in potentially
explosive areas, such as petrol stations,
chemical plants and blasting areas.
Interference of other electronic equipment may occur
if the equipment is inadequately protected.

3.2 Antenna precautions

The combined gain of the cable-antenna solution
used for this product must not exceed 1.4 dBi
(850 MHz) and 3.0 dBi (1900 MHz).
3.3 Radio frequency radiation exposure
information
This equipment complies with FCC radiation
exposure limits set forth for an uncontrolled
environment. This equipment should be installed and
operated with a minimum distance of 20 cm between
the radiator and your body.
This transmitter must not be co-located or operated
in conjunction with any other antenna or transmitter.
This device complies with Part 15 of the
FCC Rules and with RSS-210 of Industry
Canada.
Operation is subject to the following two
conditions:
Note
1. This device may not cause harmful
interference, and
2. this device must accept any
interference received, including
interference that may cause undesired
operation.
Changes or modifications made to this
equipment not expressly approved by
Note
Grundfos may void the FCC authorisation
to operate this equipment.

3.4 Fitting a GSM antenna

The antenna supplied with the CIM 2XX must be
connected to the CIM 2XX to establish connection to
the GSM network.
If the CIM 2XX is installed in a metal
Note
control cabinet, Grundfos recommends to
fit an external GSM antenna.
External antenna
See fig. 2.
Connect the antenna cable to the SMA connection
(pos. 1) of the CIM 2XX. The antenna must be
installed outside the control cabinet in a position with
good reception conditions.
1
2
Fig. 2 Fitting an external GSM antenna
Pos. Description
1 SMA connection for GSM antenna
Antenna cable for external GSM
2
antenna
5