Fitting & Operation Information - Cosatto GIGGLEMIX TRAVEL SYSTEM Manual Del Usuario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
Fitting & operation information:
Please refer to the following diagrams:
Chassis
1-
2-
Front wheel
3-
4-
Rear wheel
5-
6-
Brake
7-
8-
Front wheel swivel
9-
lock
10-
Basket
11-
Chassis
12-
Convertible seat
unit
13-
14-
15-
16-
17-
18-
19-
Pram mode
20-
21-
Hood
22-
23-
Opening:
Release the autolock (a) and lift the handle upwards until the chassis locks into
position (b).
Check the chassis has locked in place.
Adjusting handle position:
Fitting:
Removing:
Fitting:
Removing:
Applying:
Releasing:
Applying:
Releasing:
Removing:
Refitting is a reversal of this procedure.
Closing:
Note: The chassis cannot be closed in pram mode or car seat mode.
To close with seat unit fitted, the seat unit must be forward facing and in the most
upright recline position.
While pressing the primary release button (a), pull both secondary levers (b) back.
Press down on the handle (c) until the autolock retains the chassis in the folded
position (d).
Fold handle inwards (refer to step 2) to achieve the most compact fold (e).
Preparation:
Unfasten the flap under the seat unit (a).
Stretch the flap over the support bar and refasten (b).
Fit (a) and secure (b) the pram liner (with mattress & insert) to the convertible seat
unit.
Attach the bumper bar to the convertible seat unit (a).
Noting the orientation of the hood frame, insert the hood frame inside the hood
frame (a) and attach the hinge poppers (b) .
Open the hood (a) and attach the remaining poppers (b).
Fit (a) and secure (b, c) the hood to the convertible seat unit.
Fit and secure (a) the tether strap to the chassis handle.
Fitting:
Note: In pram mode, the seat unit should only be fitted rearward facing.
The pushchair is suitable from birth until the child is ready for a fully seated
position (pushchair mode).
Must only be used in lie flat position.
Dots are marked on the seat mounts and carrycot mounts (a). These should be on
the same side and aligned if fitted correctly.
Removing:
Note: Please ensure that the bumper bar is securely fitted before lifting the
convertible seat unit clear of the chassis.
Adjusting:
Removing:
4
Tabla de contenido
loading

Tabla de contenido