Hints And Tips - Grundig WK 5040 Manual De Instrucciones

OPERATION _______________________________
Preparation
1 Remove all packaging and sticker materials
and dispose of them according to the
applicable legal regulation.
2 Before using of the appliance for first time,
clean all parts which come into contact with
water carefully.
(See the "Cleaning and care" section).
3
Completely roll out the power cord
the power cord storage
the base . Pass the power cord through the
J
slot on the base.
4 Fill the water tank
G
5
Set the kettle on its base
the kettle is sitting in an upright position and
that it is sitting on the base correctly and in a
stable position.
6 Pour out the hot water and rinse the kettle
with water. This will remove any remaining
manufacturing residues from the inside of the
water tank .
G
7
Clean kettle well before initial use and discard
water of first two boiling cycles.
Operation
1
Push the lid release button
open the lid .
A
– The lid opens automatically.
A
2
Fill the water tank
G
Note
Do not place the water tank
■
while filling it with water.
J
Never fill the water tank
■
maximum level indicator or below the
minimum level indicator.
3
Close the lid until it clicks into place.
A
4
Place the water tank
sure that it is sitting in an upright and stable
position.
5 Insert the plug into the wall socket.
6 Press down On/Off switch
– Power on indicator
heating process begins.
12 ENGLISH
from
L
on the bottom of
K
with water.
. Make sure that
J
on the kettle to
D
with water.
on the base
G
above the
G
on the base . Make
G J
.
I
illuminates and
H
Note
Lid should always be closed during the
A
■
heating process; otherwise the kettle will not
switch off automatically.
7 After a few minutes, the water will start to boil.
The kettle switches off automatically and On/
Off switch moves upwards.
I
- Power on indicator
Note
If you want to stop the heating manually, push
■
the On/Off switch
indicator goes off.
H
8
Disconnect the plug from the wall socket.
9
Take the water tank
hold it by the handle
Caution
Do not open the lid
■
splash out. Make sure that no water splashes
onto the base .
J
10
Pour the water from the spout
or glass you want to use.
Note
If you want to continue the heating process,
■
repeat the procedure from 1 to 10.
Let the kettle cool down between each heating
■
process.

Hints and Tips

The kettle is equipped with a filter
■
filters out limestone and other residues when
the water is being poured out.
Use softened or filtered water to prevent lime
■
build-up.
goes off
H
upwards. Power on
I
from the base . Only
G J
.
E
as hot water could
A
to the cup
B
which
C