Child-Proof Lock - Beko WML 15040 KL Manual De Instrucciones

cancelled or selected in accordance with
the step the program is at. The door can be
opened if the water level is suitable. Laundry
may be added / taken out by opening the
door.

Child-proof lock

You can protect the appliance from being
tampered by children by means of the child-
proof lock. In this case, no change can be
made in the running program.
The machine is switched to child-lock by
pressing the 1st and 2nd auxiliary functions
from the left for 3 sec. 1st auxiliary function
light will flash continuously. To deactivate the
child-proof lock, press the same buttons for
3 sec.
Ending the program through
canceling
In order to cancel the selected program,
press the "Start/Pause/Cancel" button for 3
seconds. The machine starts to discharge
the water. "Wash" and "Program Finished"
lights will light up. "Start/Pause/Cancel" and
"Wash" lights will go off after discharging
process is over and the "Lid" light will start
flashing. "Lid" lamp will light up continuously
when the door is unlocked.
If the program is cancelled in the middle
of the process, "Wash" and "Program
Finished" lights will light up. The machine
can drain all the water or can take in water
for 3 times at most to cool down the clothes
and complete draining process. When the
water discharging process is completed,
the "Wash" light will go off, the "Program
Finished" light will light up and the "Lid"
light will continuously flash until the door is
unlocked.
End of program
The "Program Finished" lamp on the
program follow-up indicator will light up
when the program comes to an end. The lid
is unlocked 2 minutes later, the "Program
Finished" and "Lid" lamps will light up
continuously. The machine is now ready for
a second cycle.
If any key is pressed when the machine is
at the end of the program or if the position
of the selection knob is changed, the
"Program Finished" light will go off and only
the "Lid" lamp will remain as lit. If the door
is still locked, the "Lid" light will continue
flashing until the door is unlocked.
Press the "On/Off" button to shut down the
machine.
5 Maintenance and cleaning
Detergent Drawer
Remove any powder residue buildup in the
drawer. To do this;
1. Press the dotted point on the siphon
in the softener compartment and pull
towards you until the compartment is
removed from the machine.
C
If more than a normal amount of
water and softener mixture starts to
gather in the softener compartment,
the siphon must be cleaned.
2. Wash the dispenser drawer and the
siphon with plenty of lukewarm water
in a washbasin.
3. Replace the drawer into its housing
after cleaning. Check if the siphon is
in its original location.
Inlet water filters
There is a filter at the end of each water
intake valve at the back side of the machine
and also at the end of each water intake
hose where they are connected to the tap.
These filters prevent the foreign substances
and dirt in the water to enter into the
machine. Filters should be cleaned as they
get dirty.
• Close the taps.
• Remove the nuts of the water intake
hoses to clean the surfaces of the
filters on the water intake valves with
an appropriate brush.
• If the filters are very dirty, you can
pull them out by means of pliers and
clean them.
• Take out the filters on the flat ends of
the water intake hoses together with
the gaskets and clean thoroughly
under streaming water.
• Replace the gaskets and filters
carefully to their places and tighten
9 - EN