Resetting The Bt Hs 112; Led Displays And Signal Tones; Fault Removal; Declaration Of Conformity - Blaupunkt BT HS 112 Manual Del Usuario

Resetting the BT HS 112

The BT HS 112 can be registered with up to eight cell phones. You can delete
the list of registered phones and reset the headset to the factory settings.
– The BT HS 112 must be switched on and no connection may exist to
a cell phone.
– Press and hold down the "+" and "–" volume buttons simultaneously for
approx. 10 seconds until the LED display intermittently fl ashes lights red
and blue.
– After the factory settings have been restored, the LED display stops fl ash-
ing intermittently.
– After the next switch-on, the BT HS 112 is in registration mode.

LED displays and signal tones

Device status LED displays
Switching on Lights blue for 3 seconds
Switching off Lights red for 3 seconds
Registration mode Flashes red and blue alternately
Standby mode Flashes blue once every 3 seconds
without connection
Standby mode Lights blue every 3 seconds
with connection
Incoming call Flashes blue
Active call Flashes blue once every 2 seconds
Mute Flashes red once every 10 seconds 2 tones every
Low battery Flashes red once every 3 seconds
Battery is charging Lights red.
Lights blue after the battery is
fully charged.
24
02_BTHS112_gb.indd 24-25 02_BTHS112_gb.indd 24-25

Fault removal

If a connection between the BT HS 112 and a cell phone cannot be established,
observe the following:
– Ensure that the battery is charged.
– Ensure that the Bluetooth function of the cell phone is activated. You fi nd
more detailed information in the operating instructions of the cell phone.
– Check whether the BT HS 112 is connected with the cell phone.
– Ensure that the distance between the BT HS 112 and a connected cell
phone is less than 10 metres and that no obstacles are between the two
devices. Obstacles can interfere with the transmission or reduce the range.
– If none of these measures is successful, please contact the service depart-
ment of your distributor.
– The BT HS 112 meets the Bluetooth specifi cation 3.0 + EDR. The fl awless
function between the BT HS 112 and Bluetooth-ready cell phones from
Signal tones
diff erent manufacturers and of diff erent types cannot be guaranteed since
it depends on the compatibility.
1 high-pitched
sound

Declaration of conformity

1 low-pitched
The Blaupunkt AudioVision GmbH & Co. KG declares that this product complies
sound
with the basic requirements and the other relevant regulations of the direc-
tive 1999/5/EC. The declaration of conformity can be found on the Internet
under www.blaupunkt.com.

Warranty

We provide a manufacturer's warranty for products bought within the
European Union. For devices purchased outside the European Union, the
warranty terms issued by our respective responsible domestic agency are
valid. The warranty terms can be called up from www.blaupunkt.com.
10 seconds
5 tones every
20 seconds
25
04.05.12 12:31 04.05.12 12:31