Volkswagen 5G1 052 200 A Instrucciones De Montaje página 6

2. Fit the 1- and 3-wire wiring harnesses:
Detach the luggage compartment cover and the luggage compartment floor coverings and remove
the rear body panel trim.
Remove the rear seat and the backrests.
Remove the right and left luggage compartment side trim.
Remove the right and left C-column cladding and the roof lining end strip.
Remove all of the interior cladding on the rear hatch.
Remove all four tail lights fitted with light bulbs. These may no longer be used after fitting the 1-
and 3-wire wiring harnesses on this vehicle!
Remove the left rear side cladding (3-door).
Remove all of the access trims on the left.
On vehicles fitted with an airbag in the side flanks of the backrest it is imperative to pay
attention to the safety precautions when removing and fitting airbag components.
Remove the covers from the left front face of the dash panel.
Remove the bonnet release lever and side trim in the left footwell.
Remove the covers from the left front face of the dash panel.
Remove the glove compartment and trim elements below the glove compartment.
Remove the left rubber grommet between the rear hatch and the chassis at the top and bottom.
On the connector for the inner right tail light remove the vehicle's grey-red wire from chamber 1 with
a suitable release tool, insert it into chamber 3 and click into place. First open the secondary
interlock carefully.
31.03.2014-051433
ATTENTION!
Left-hand drive vehicles:
Remove the trims from underneath the BCM.
Right-hand drive vehicles:
Remove the side trim in the left footwell.
6 / 52