General Safety Notes; Notes On Ul Approval; Correct Use; Commissioning - SICK GRSE18 Instrucciones De Operación

1

General safety notes

2

Notes on UL approval

3

Correct use

4

Commissioning

4.1

Check the application conditions

8016954.1ABM / 2020-12-21 | SICK
Subject to change without notice
Read the operating instructions before commissioning.
■
■
Connection, mounting, and configuration may only be performed by trained
specialists.
■
NO
2006/42/EC
Not a safety component in accordance with the EU Machinery Directive.
SAFETY
■
Do not install the sensor at locations that are exposed to direct sunlight
or other weather influences, unless this is expressly permitted in the operating
instructions.
These operating instructions contain information required during the life cycle of
■
the sensor.
UL: Only for use in applications in accordance with NFPA 79. These devices shall be
protected by a 1 A fuse suitable for 30 V DC.
Adapters listed by UL with connection cables are available.
Enclosure type 1.
The GRSE18 is an opto-electronic through-beam photoelectric sensor (referred to as
"sensor" in the following) for the optical, non-contact detection of objects, animals, and
persons. A sender (GRS) and a receiver (GRE) are required for operation. If the product
is used for any other purpose or modified in any way, any warranty claim against SICK
AG shall become void.
Observe the application conditions: Adjust the distance between the sender and the
receiver according to the corresponding diagram (x = sensing range, y = operating
reserve).
If several through-beam photoelectric sensors which are installed next to one another
are to be used, we recommend swapping the sender/receiver arrangement at every
second through-beam photoelectric sensor and ensuring that there is sufficient dis‐
tance between the through-beam photoelectric sensors. By doing this, mutual interfer‐
ence can be prevented.
GENERAL SAFETY NOTES
1
5