Tabla de contenido
Idiomas disponibles
Idiomas disponibles
*TV200 / 390001
11/14/03
7:28 AM
• Use sharp drill bits only.
• Support and secure work properly, as instructed in the Safety
Instructions.
• Use appropriate and required safety equipment, as instructed in the
Safety Instructions.
• Secure and maintain work area, as instructed in the Safety Instructions.
• Run the drill very slowly, using light pressure, until the hole is started
enough to keep the drill bit from slipping out of it.
• Apply pressure in a straight line with the bit. Use enough pressure to
keep the bit biting but not so much as to stall the motor or deflect the
bit.
• Hold the drill firmly to control its twisting action..
• DO NOT CLICK THE TRIGGER OF A STALLED DRILL OFF AND ON IN
AN ATTEMPT TO START IT. DAMAGE TO THE DRILL CAN RESULT.
•Minimize stalling on breakthrough by reducing pressure and slowly
drilling through the last part of the hole.
•Keep the motor running while pulling the bit out of a drilled hole. This
will help reduce jamming.
•When using twist drill bits to drill holes in wood, it will be necessary to
pull the bits out frequently to clear chips from the flutes.
• Make sure switch turns drill on and off.
WARNING: It is important to support the work properly and to
hold the drill firmly to prevent loss of control which could cause
personal injury. If you have any questions on how to properly operate
tool, call: 1-800-544-6986
OPERATION
DRILLING IN WOOD
Holes in wood can be made with the same twist drill bits used for metal
Page 5
or with spade bits. These bits should be sharp and should be pulled out
frequently when drilling to clear chips from the flutes.
DRILLING IN METAL
Use a cutting lubricant when drilling metals. The exceptions are cast
iron and brass which should be drilled dry. The cutting lubricants that
work best are sulfurized cutting oil or lard oil; bacon grease will also
serve the purpose.
DRILLING IN MASONRY
Use carbide tipped masonry bits. Refer to Drilling section. Keep even
force on the drill but not so much that you crack the brittle material. A
smooth, even flow of dust indicates the proper drilling rate.
The RBRC™ Seal
The RBRC™ (Rechargeable Battery Recycling Corporation)
Seal on the nickel-cadmium battery (or battery pack)
indicates that the costs to recycle the battery (or battery
pack) at the end of its useful life have already been paid
by the manufacturer. In some areas, it is illegal to place spent
nickel-cadmium batteries in the trash or municipal solid waste stream
and the RBRC program provides an environmentally conscious
alternative.
RBRC™ in cooperation with battery manufacturer, has established
programs in the United States to facilitate the collection of spent nickel-
cadmium batteries.
Help protect our environment and conserve natural resources by
returning the spent nickel-cadmium battery to an authorized battery
manufacturer or to your local retailer for recycling. You may also
contact your local recycling center for information on where to drop off
the spent battery.
Use only mild soap and damp cloth to clean the tool. Never let any
5
MAINTENANCE
Tabla de contenido
