Delabie 2443 Manual Del Usuario página 5

INSTALLATION
• Supply with cold water and hot water at a maximum temperature of 70°C (we recommend 45°C).
• Supply pressure: 1 bar (100 kPa) to 5 bar (500 kPa), we recommend 3 bar (300 kPa).
Maximum pressure differential at the inlets: 1 bar.
RECESSED MIXER
• Provide a recessing area in the wall: H. 125 x L. 125mm, 50 - 70mm deep (fig. A).
• Remove the control lever (fig. B) by removing the cover  and unscrew the grub screw using a 2.5mm
Allen key . Remove the Ø 116mm sliding wall plate.
• Place the mixer in the recessing area and connect the water supply and the outlet to the shower with
the M1/2" pipes, and seal the assembly (fig. C1 & C2).
• Fill the recessing area so that the mixer body cannot be removed, (fig. C3).
• Make sure there is a waterproof seal between the wall plate and the wall (fig. D). Leave a gap at
the bottom to allow any residual water to drain away.
• Mount the sliding wall plate against the wall (fig. E1) and replace the control lever on the square
section of the cartridge (fig. E2).
THE INSTALLER MUST ENSURE:
• THE SEAL AROUND THE RECESSING HOUSING IS WATERPROOF TO PREVENT ANY INGRESS
OF WATER;
• ANY WATER ACCIDENTALLY ENTERING THE RECESSING HOUSING (E.G. CONDENSATION,
RUN OFF, LEAKS, ETC.) HAS AN EXTERNAL DRAINAGE POINT TO PREVENT ANY STAGNATION;
• THE INTEGRITY OF THE SEALS BETWEEN THE STAINLESS STEEL WALL PLATE AND THE WALL
OR THE WALL PLATE AND THE MIXER AT LEAST ONCE A YEAR, AND MAKE GOOD IF NECESSARY.
If this advice is not followed, water may leak into the wall.
DELABIE cannot be held responsible for any ingress.
FOR FURTHER INFORMATION PLEASE CALL DELABIE TECHNICAL SUPPORT UK: 01491 821821.
ALL OTHER MARKETS: +33 (0)3 22 60 22 74.
REMEMBER
• Our mixers must be installed by professional installers in accordance with current regulations
and recommendations in your country, and the specifications of the fluid engineer.
• Sizing the pipes correctly will avoid problems of flow rate, pressure loss and water hammer
(see calculation table in our brochure and online at www.delabie.com).
• Protect the installation with filters, water hammer absorbers and pressure reducers to reduce
the frequency of maintenance (recommended pressure from 1 to 5 bar maximum).
• Install stopcocks close to the mixer to facilitate maintenance.
• The pipework, filters, non-return valves, stopcocks, bib taps, cartridge and all sanitary fittings should
be checked at least once a year, and more frequently if necessary.
EN