Kathrein UFO 356/TP Manual De Instrucciones página 17

The operating mode "CW mode" can only be set in the channel unit I menu. Channel unit II is then also switched to "CW mode".
Note:
If settings are saved in operating mode "CW mode" (with button "M"), operating mode "DVB-T-SIG" is set on channel unit II
when CW mode is exited. If another operating mode was selected, this must be set again.
Display in CW mode:
Twin I
Outp. S21
--- MS/s
Main menu, display in CW mode
6 Selecting the state of the output spectrum
Twin I
Inp. K10
Outp. S21
6.900 MS/s
Main menu
The state of the output signal is selected in the QAM stages sub-menu. Press the (sub-menu) key to switch to the sub-menu
and use the "+" and "-" buttons to make the desired setting.
The following settings are possible: "normal"/"inverse". Then press the (sub-menu) key to exit the sub-menu.
7 Settings at system level
Note:
Controller bus demultiplexer UFX 312 (BN 20610040) must be used to make settings at the system level.
The double arrow buttons (<< >>) are used to select the central controller. The procedure is exactly the same as for
the channel units.
When the central controller is selected, its LED lights up yellow.
► Language setting
**** System
Set language
Selection
Main menu
CW
306.00 MHz
64 QAM
TP
212.5 MHz
306.00 MHz
64 QAM
****
with +/-
*** UFO 356/TP-I
Modulation
Spectrum
QAM stage sub-menu, CW setting
*** UFO 356/TP-I
Modulation
Spectrum
QAM stage sub-menu
**** Language
English
Language sub-menu
***
CW mode
normal
***
DVB-T-Sig
normal
****