Kathrein UFO 356/TP Manual De Instrucciones página 14

3 Selecting output channel or output frequency
Twin I
Inp. K10
Outp. S21
6.900 MS/s
Main menu
3.1 Frequency fi ne tuning
*** UFO 356/TP-I
Outp. Freq.
Outp. Level
Outp. HF
Output frequency sub-menu
3.2 Selecting the output level
*** UFO 356/TP-I
Outp. Freq.
Outp. Level
Outp. HF
Output frequency sub-menu
3.3 Switching outputs on/off
*** UFO 356/TP-I
Outp. Freq.
Outp. Level
Outp. HF
Output frequency sub-menu Twin I
Use the parameter "RF output on/off" to switch the output channels on/off independently. Use the "+" and "-" buttons to make
the selection.
Note:
The output frequency and level setting can only be set if Twin I is selected.
This also applies if channel unit Twin I is switched off.
TP
212.5 MHz
306.00 MHz
64 QAM
***
306.00 MHz
0 dB
on
***
306.00 MHz
-4 dB
on
***
306.00 MHz
0 dB
on
The output frequency for Twin I can be set continuously from
114 MHz to 850 MHz in 8 MHz steps using the "+" and "-"
buttons.
The channel is only displayed where applicable i.e. if the set
frequency coincides with the standard.
Due to the fi xed channel adjacency, the output frequency for
Twin II is derived from the settings of Twin I
(f = f + 8 MHz)
II I
The output frequency can be fi ne tuned in 250 kHz steps in
the output channel sub-menu.
Press the (sub-menu) key to switch to the sub-menu and use
the "+" and "-" buttons to set the required frequency.
Then press the (sub-menu) key to exit the sub-menu.
The output level can be set continuously from 0 to -10 dB in
1 dB steps using the "+" and "-" buttons. The output level can
be set in the output frequency sub-menu. Press the (sub-
menu) key to switch to the sub-menu and use the "+" and "-"
buttons to set the desired level.
Then press the (sub-menu) key to exit the sub-menu.
The output level for both channel units is set via Twin I.
*** UFO 356/TP-II
Outp. Freq.
Outp. Level
Outp. HF
Output frequency sub-menu Twin II
***
314.00 MHz
0 dB
on