Kathrein UFO 356/TP Manual De Instrucciones página 13

1 Selecting channel unit Twin I or Twin II
The display always refers to one of the two channel units processed by the module (I or II).
First select the channel unit for which you wish to change the settings.
Note:
The channel unit with the lower output frequency is Twin I. Twin I is used to set the output frequency and output level.
Twin I
Inp. K10
Outp. S21
6.900 MS/s
2 Selecting the input channel or input frequency (example shows Twin I)
Twin I
Inp. K10
Outp. S21
6.900 MS/s
2.1 Additional input parameters
The following parameters are found in the input channel sub-menu (here Ch10):
*** UFO 356/TP-I
Frequency
RF bandwidth
Prio non
Input frequency sub-menu
TP
212.5 MHz
306.00 MHz
64 QAM
* TP
212.5 MHz
306.00 MHz
64 QAM
***
212.5 MHz
7 MHz
C/N 15 dB
Use the "<<" and ">>" buttons to select "Twin I" or "Twin II".
After selecting the input channel fi eld, set the required
channel (e.g. Ch10) on the controller using the "+" and "-"
buttons.
The input frequency displayed is the channel centre
frequency. The input channels can be set in 7 MHz or 8 MHz
steps depending on the TV standard selected.
Input frequency: Set using "+" and "-" buttons in 500 kHz
steps or digit-by-digit in range from
174 MHz to 230 MHz and from 470 to
862 MHz
RF bandwidth: Set using "+" and "-" buttons to 7 MHz
or 8 MHz
C/N: Current value on input is displayed