Cleaning And Maintenance; Cleaning And Care; Interior Cleaning - Brandt BFC584YNW-YNX Guía De Instalación Y Uso

4. CLEANING AND MAINTENANCE

Cleaning and care

For hygienic reasons,
(including exterior
accessories) should be cleaned regularly at
least every two months.
Caution! The appliance must not be
connected to the mains during cleaning.
Danger of electrical shock! Before cleaning
switch the appliance off and remove the
plug from the mains socket.
Exterior cleaning
Clean your appliance regularly to maintain
its good appearance.
Wipe the digital panel and display panel
-
with a clean, soft cloth.
Spray water onto the cleaning cloth
-
instead of spraying directly on the
surface of the appliance. This helps
ensure an even distribution of moisture
to the surface.
Clean the doors, handles and cabinet
-
sur- faces with a mild detergent and
then wiped dry with a soft cloth.
Caution!
Don't use sharp objects as they are likely
-
to scratch the surface.
Don't use Thinner, Car detergent,
-
Clorox, ethereal oil, abrasive cleansers
or organic solvent such as Benzene for
cleaning. They may damage the surface
of the appliance and may cause fire.

Interior cleaning

You should clean the appliance interior
regularly. It will be easier to clean when
food stocks are low.
Wipe the inside of the fridge freezer with
a weak solution of sodium bicarbonate,
and then rinse with warm water using a
wrung-out sponge or
completely dry before replacing the
shelves and baskets.
Thoroughly dry all surfaces and removable
parts.
Although this appliance automatically
defrosts, a layer of frost may occur on the
freezer compartment's interior walls if the
freezer door is opened frequently or kept
open too long. If the frost is too thick,
choose a time when of food stocks are low
and proceed as follows:
the appliance Remove existing food and accessories
1.
and interior baskets, unplug the appliance from the
mains power and leave the doors open.
Ventilate
accelerate the thawing process.
When defrosting is completed, clean
2.
your freezer as described above.
Caution! Don't use sharp objects to
remove
compartment. Only after the interior is
completely dry should the appliance be
switched back on and plugged back into
the mains socket.
Door seals cleaning
Take care to keep door seals clean.
Sticky food and drinks can cause seals to
stick to the cabinet and tear when you
open the door. Wash the seal with a mild
detergent and warm water.
Rinse and dry it thoroughly after
cleaning.
Caution! Only after the door seals are
completely dry should the appliance be
powered on.
Replacing the LED light:
Warning: The LED light must not be
replaced by the user! If the LED light is
damaged, contact the customer helpline
for assistance. To replace the LED light,
the below steps can be followed:
Unplug your appliance.
1.
Remove light cover by pushing up and
2.
out.
Hold the LED cover with one hand and
3.
pull it with the other hand while pressing
the connector latch.
cloth. Wipe
Replace LED light and snap it
4.
correctly in place.
19
the room thoroughly
frost from the freezer
to