Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
ON-GOING MAINTENANCE OF YOUR APPLIANCE
3 /
DEFROSTING
Your refrigerator has an automatic defrosting system. The
appliance's rear surface becomes covered with frost when the com-
pressor is working and defrosts when the compressor is off. When
the frost melts, the water evaporates by itself.
The
compartment must always be defrosted when the
layer of frost is approximately 4mm thick. In any case, this compart-
ment must be defrosted at least once a year.
You may use the plastic spatula supplied with the appliance but
never use any metal item or an electrical appliance.
Disconnect your refrigerator before proceeding to defrost it.
• Pack your frozen food in a freezer bag and keep it cool.
• Leave the door open and sponge away the melt water as it forms.
• To accelerate the defrosting process, you can place a bowl of hot
water in the compartment and close the door.
• Once defrosting is complete, proceed to clean your appliance.
CLEANING AND MAINTENANCE
Switch off your refrigerator before proceeding to clean it.
We recommend that you clean and disinfect your appliance
regularly
• Clean the interior with water and bicarbonate of soda using a
sponge or a dishcloth to prevent any bad smells occurring.
• Never, under any circumstances, use solvents or abrasive deter-
gents because these could damage the interior of your appliance.
Also do not put any of the interior's accessories in the dishwasher.
• We recommend that you dust the back of the appliance with a
cloth once a year because if it is dirty, your refrigerator's output
reduces and its consumption increases.
CHANGING THE LIGHT BULB
Disconnect your appliance before proceeding to change the
light bulb.
• The bulb is behind the thermostat panel. Remove the grill.
• Remove the bulb by unscrewing it counter-clockwise.
• Insert a new bulb of the same power as its predecessor.
• Replace the grill, reconnect the appliance and switch it on.
08
Capítulos
Tabla de contenido
